Front Door Lock Broken And Can T Open Door
The door could be misaligned so that although the door can be unlocked while the door is ajar when closed the door cannot unlock.
Front door lock broken and can t open door. Locate the screws holding the lock in place on the inside of the door. Locks jam up for multiple reasons. Remove these screws unscrew one side of the door knob and pull the door handle and lock assembly out of the door. Remove the screws from the adapter plate and pull the plate from the door if the spindle fails to turn.
You can try drilling the lock cylinder to see if that will release it but make sure you have a replacement purchased first. Weather stripping may cause the door lock to be misaligned and prevent the door lock from functioning properly. Flip the key and open the door. The lock cylinder may be broken so that you cannot use your key or anything else to move your door lock into the unlocked position.
This problem is particularly bad if the knob is on an inside door since it stops you from being able to get into that room without climbing through a window. If this is the case remove the weather stripping and place the stripping further back on the door frame. A broken door handle can be a real headache especially when it locks on its own and can t be opened. The same solutions apply to when you are solving the issue with most broken locks.
One common reason for a door lock jamming is the buildup of debris that clocks the internal mechanisms. You can always break down the door and buy a new one. How to open a door that s locked and cant be opened with the handle or knob. Each of these door lock problems has different causes but the end point is usually the same.
Once you have the door handle off you can now try to open the latch manually with either a large flathead screwdriver or pair of needle nose pliers. This will give you the backset size that you will need. Also if the latch or lock bolt is broken the door lock will be jammed. This is a far easier solution than moving the lock.
You will need to measure from the edge of the door to the middle of the lock cylinder where the key goes in. Try turning the spindle clockwise to retract the latch from the strike and open the door. Remove the old lock. You can see where the cylinder entered the dead latch mechanism and pulled the latch back.
Make sure the lock is unlocked before you do this. Don t use a wet. Spray the door key with a graphite based lubricant.